Quick Answer: How Do You Remove A Water Heater Element Without A Wrench?

What size socket do I need to remove a water heater element?

Drive x 1-1/2 in.

Water Heater Socket.

Made to fit the most common size of electric water heater element, the 6-point opening snugly fits the hex end of the element so you can apply maximum torque without slipping..

Can I replace a 3500 Watt water heater with a 4500 Watt?

When selecting element, buy same wattage or less wattage… keep volts the same. It is ok to install higher watt up to 5500 on 4500 watt heater if breaker is 30 amp and wire is 10 gauge. It is ok to install lower watt: replace 4500 with 3500 as long as voltage is same.

Does water heater element length matter?

Does the length of a water heater heating element make a difference? No, not as long as you have the proper voltage, watts and style. Shorter elements have a larger diameter therefore the same surface area.

What is an element wrench?

The Camco 09883 Element Wrench is a convenient and handy tool for repairs and home improvement projects. It is plated with zinc for extra strength, and can fit all screw-in elements and 1.5″ nuts. This 5″ wrench can be used in conjunction with your screwdriver, and is a nice alternative to an adjustable wrench.

Do you have to drain water heater to replace element?

If you need to replace the heating element in your electric water heater, you may be thinking that you need to first drain the tank. … If the gasket sticks,remove the new gasket from the replacement element and re-use the old gasket. NOTE: You can not drain a heater from the high temp pop valve.

How do you remove a seized water heater element?

Mix a solution of half vinegar and half water in a small cup. Dip a toothbrush into the solution and brush it between the seam of the heating element and the side of the heating tank. Apply the solution liberally, but do not allow it to drip heavily. Allow the solution to sit for 20 minutes.

Are water heater elements Universal?

There are three types: screw in, bolt in and clamp in. They all have different wattage ratings and can work on either 120 or 240 voltage.

How tight should a water heater element be?

With the gasket in place, install the new element by reversing the removal process and turning the element in a clockwise direction. Screw the component in finger-tight, and then use your water heater element wrench to tighten it another 1/2 to 1 turn.

Can I replace a 3800 Watt water heater with a 4500 Watt?

Also, can I replace a 3800 Watt water heater with a 4500 Watt? You can buy 3800 watt elements to replace the 4500 watt units. This is commonly done when the electric is NOT 10 gauge wire with 30 amp breaker.